1, boot heating, you should check whether the normal transfer silicone roll, shutdown, should pay attention to set the sweltering delay is normal, not directly off (sweltering delay is set at 40-50 minutes is appropriate); 2, the machine at work in case of power failure, or other causes sudden stop, should immediately put on gloves, while rotating rubber roller side to remove it put the heat elsewhere, in order to avoid uneven heating to burn silicone roller; 3, replace the rubber roller tight when silica, silica gel, etc. should be heated to the desired temperature then lock securing, but not too tight; 4, silicone roll usually surface should be kept clean to avoid the transfer film and other debris stuck to the roller surface, such as surface dirt has been available cloth surface cleaning alcohol industry. If stubborn dirt used fine sandpaper. 5, the same as with other printing Cots, silicone roll during use or storage, not with other hard objects (such as wrenches) collision, extrusion bar; away from corrosive materials; about 6, silicone temperature is generally 190 degrees to the normal transfer in the case of qualified product transfer, should try to reduce the pressure and temperature silicone roller.